Need some advice? - 01293 821 345 - energy@iso.co.uk

Ecoforest heat pumps mainly use the same type of controller although they are always configured specifically for your heat pump installation. These configurations are normally set during system commissioning. However, there are some parameters and controls which you can configure yourself should you need to tweak the system, perhaps to increase the amount of hot water if more people are staying in the house, or because you need to set up night time reduction, or to clear an alarm. To easily explain these controls we have created a series of short video clips that demonstrate how the changes are made.

Introduction to the Ecoforest heat pump controller

Changing the heating temperature

Changing the hot water temperature

Activating night reduction mode

Checking and clearing alarms

Turning your system on and off

0
0
0
s2smodern

RECC     9 1 small    5 1 small       GSHPA   

Copyright © isoenergy 2019